In this report we’re going to examine how to create your own dog mask. We’ll cover the basics and then go on to take a look at some of the more advanced tips and tricks which you can use.
For those who have a dog that likes to bark, http://hotel-club-ksar-eljem.tn/?p=30340 and especially if your dog loves to play in the garden and other regions of the house, you will need to get them some particular dog protection.
Paper Plate 3d Dog Mask DIY Materials: This is the initial part of the set-up that will look a little scary at first, but it’s really very simple. All you have to do is take a cardboard cutting board and cut the cardboard into the shape of your mask. You can not just cut a rectangular shape out of the cardboard, so you’ll have to cut around the edge of the mask so that you get something which resembles a cone. The most important thing here is to be realistic with what kind of paper plate which you’re using.
Then you’ll need to wrap the cardboard around the edges of the paper plate, making sure that there is a good seal between the two pieces so that you can ensure that nothing will leak once you put the mask on. Be sure the edges are cut so that the edges are not sharp, as this may damage the edges of the mask.
Glue it on! The next step involves using some paint. You should spray the paint over the cardboard, making certain it runs smoothly and evenly across the whole mask. You’ll want to start with one side of the mask first, so that you can work your way round it before moving onto the other side. The paint needs to be slightly thicker than the cardboard, and it is best that you leave about one-third of an inch of paint on the edges so that it runs across the cardboard.
Don’t fret too much about the paint getting stuck into your mask. It’s easy to remove it later, and it will leave you with a wonderful finished mask to show off to everybody! It’s also a good idea to wash away any excess paint after you’re done, so you don’t wind up with smudges or smears on your dog.
Then it’s time to glue the mask onto your dog’s head. First you need to be certain that you have a secure fit between the mask and your dog’s head. As soon as you’ve made sure that it’s secure, then you can begin to glue the mask onto the dog’s face. Take the piece of cardboard that is used for the foundation of the mask and fold it over. Make sure that it’s quite strong and then use your hands to secure the cardboard down in place.
Keep your hands out of the way and use tape to hold it in place as you repeat the procedure on the cardboard folds until you have the mask snugged securely onto the face of your dog. Don’t make the folds too big or else it could look messy. As soon as you’ve done this, you can then take out the mask and attach the cardboard ears. And attach the other part of the mask onto the dog. Be sure that the ears are level and be sure that it is not too short or long as this will cause some problems with the mask slipping off the dog’s face.
If you are using a dog mask because your dog protection, you’ll need to do some sanding to be certain it is secure on your dog. You can do it by sanding off any excess paper that may have been removed from your mask.